Grand Caravan AWD V6-3.8L VIN L (2001)
14. Install the nut retainer and cotter pinon the stub shaft of the outer C/V joint.
15. Install the wheel speed sensor on the hub/bearing and adapter. Install the wheel speed sensor attaching bolt. Tighten the wheel speed sensor
attaching bolt to a torque of 12 Nm (105 inch lbs.).
16. Install wheel and tire.
17. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 135 Nm (100 ft. lbs.).
18. Remove jackstands or lower hoist.
CAUTION: Before moving vehicle, pump the brake pedal several times to Insure the vehicle has a firm brake pedal to adequately stop vehicle.
19. Road test vehicle to ensure proper operation of the brake system.