Intrepid V6-2.7L VIN R (2003)
3. Using lubriplate or equivalent, coat the bearing surface of brake pedal pin.
4. Connect booster input rod to brake pedal pin and install a NEW retainer clip. Use only a new retainer clip DO NOT USE the old clip.
NOTE: Before installing master cylinder, reposition under hood wiring harness above master cylinder mounting studs, in front of booster.
5. Carefully position master cylinder on booster. Position wire harness routing bracket onto right master cylinder mounting stud.
6. Install and tighten the 2 master cylinder to booster mounting nuts to 28 Nm (250 inch lbs.) torque.
7. Reconnect brake fluid level sensor connector.
8. Connect all vacuum hoses onto the booster vacuum check valve.
9. Check brake lamp switch operation.
10. Install the wiper module reinforcement on the vehicle. Install the 8 bolts, attaching the reinforcement to the strut towers. Install the bolt attaching
the wiper module to the reinforcement.
11. Install the covers over the wiper module and the cowl. Install and securely tighten the attaching screws.
12. Reconnect the battery ground cable to the ground stud on the shock tower.
13. Turn windshield wipers ON, then OFF, in order to park wipers in the proper position before installing wiper arms.
14. Install the wiper arms on the pivots. Install and securely tighten the wiper arm to pivot attaching nuts. Install the caps on the wiper arms covering
the pivot nuts.
15. Verify proper operation of the power brake booster and brake system.
