Intrepid V6-2.7L VIN R (2003)
Cruise Control Servo Cable: Service and Repair
REMOVAL
1. Disconnect the negative battery cable.
2. Remove speed control cable from throttle cam by sliding clasp out hole used for throttle cable.
3. Compress the retaining tabs on the cable and slide cable out of bracket.
4. Remove 2 nuts and 1 bolt from servo bracket.
5. Disconnect electrical connectors and vacuum hose.
6. Remove two nuts attaching speed control cable and mounting bracket to servo.
7. Pull cable away from servo to expose retaining clip and remove clip attaching cable to servo.
8. Remove servo mounting bracket.
INSTALLATION
1. Slide cable into throttle cable bracket and engage retaining tabs.
Disconnecting Throttle Cable-Typical
2. Rotate the throttle cam forward to the wide open position and install speed control cable clasp.
3. Rotate the throttle cam forward to the wide open position and install throttle cable clasp.
4. Install retaining clip to cable at servo.
5. Insert servo studs through holes in the mounting bracket and speed control cable.
6. Install nuts, tighten to 6.7 Nm (60 in. lbs.).
7. Connect vacuum hose to servo.
8. Connect electrical connector.
9. Install servo and bracket and tighten nuts and bolt.
10. Connect negative battery cable.
