Intrepid V6-2.7L VIN R (2003)
NOTE: It is normal for the water pump to weep a small amount of coolant from the primary weep hole (black stain at weep passage). Do not replace
the water pump if this condition exists. Replace the water pump if a heavy deposit or a steady flow of engine coolant is evident from the
primary weep passage . This indicates a shaft seal failure and pump must be replaced. Coolant may leak from the secondary weep passage and
fill the valley of the engine. If this condition is found, clean the primary weep passage of debris. Be sure to perform a thorough analysis before
replacing water pump.
WARNING: DO NOT REMOVE PRESSURE CAP WITH THE SYSTEM HOT AND PRESSURIZED. SERIOUS BURNS FROM COOLANT
CAN RESULT.
1. Drain cooling system.
2. Remove radiator upper crossmember.
3. Remove radiator fan.
4. Remove accessory drive belts.
NOTE: The water pump is driven by the primary timing chain.
5. Remove the timing chain and all chain guides.
6. Remove bolts attaching water pump to block.
7. Remove water pump and gasket.
INSPECTION - 2.7L
