Intrepid V6-2.7L VIN R (2003)
Compressor Clutch: Description and Operation
The compressor clutch assembly consists of a stationary electromagnetic coil, a hub bearing and pulley assembly and a clutch plate. The electromagnetic
coil unit and the hub bearing and pulley assembly are each retained on the nose of the compressor front housing with snap rings. The clutch plate is
retained with a bolt. These components provide the means to engage and disengage the compressor from the engine serpentine accessory drive belt.
When the clutch coil is energized, it magnetically draws the clutch into contact with the pulley and drives the compressor shaft. When the coil is not
energized, the pulley freewheels on the clutch hub bearing, which is part of the pulley The compressor clutch and coil are the only serviced parts on the
compressor.
The compressor clutch engagement is controlled by several components: the a/c heater control head (ATC or MTC), the evaporator temperature sensor,
the a/c pressure transducer, the compressor clutch relay, and the Powertrain Control Module (PCM). The PCM may delay compressor clutch
engagement for up to 30 seconds. Refer to Electronic Control Modules for more information on the PCM controls.
