Intrepid V6-2.7L VIN R (2003)
Compressor Clutch Coil: Component Tests and General Diagnostics
The battery must be fully-charged before performing the following tests. Refer to Battery for more information.
1. Connect an ammeter (0 to 10 ampere scale) in series with the clutch coil terminal. Use a voltmeter (0 to 20 volt scale) with clip-type leads for
measuring the voltage across the battery and the compressor clutch coil.
2. In A/C, mix, defrost and the blower motor switch in the lowest speed position, start the engine and run it at normal idle.
3. The compressor clutch coil voltage should read within 0.2 volts of the battery voltage. If there is voltage at the clutch coil, but the reading is not
within 0.2 volts of the battery voltage, test the clutch coil feed circuit for excessive voltage drop and repair as required. If there is no voltage
reading at the clutch coil, use a DRB III scan tool and testing of the compressor clutch circuit. The following components must be checked and
repaired as required before you can complete testing of the clutch coil:
-
Fuses in the junction block and the Power Distribution Center (PDC)
-
A/C heater control head
-
Compressor clutch relay
-
A/C pressure transducer
-
Evaporator temperature sensor
-
Powertrain Control Module (PCM).
4. The compressor clutch coil is acceptable if the current draw measured at the clutch coil is approximately 2.2 amperes with the electrical system
voltage at 11.5 to 12.5 volts. This should only be checked with the work area temperature at 21 °C (70 °F). If system voltage is more than 12.5
volts, add electrical loads by turning on electrical accessories until the system voltage drops below 12.5 volts.
a. If the clutch coil current reading is four amperes or more, the coil is shorted and should be replaced.
b. If the clutch coil current reading is zero, the coil is open and should be replaced.
