Intrepid V6-2.7L VIN R (2003)
Service Port HVAC: Service and Repair
SERVICE PORT VALVE CORE
Fig. 14 A/C System Service Ports - 3.2L/3.5L
REMOVAL
The 3.2 / 3.5L service port valve cores are located on the top of the manifold (High Side) and front side of the manifold (Low Side). The 2.7L service
port valve ports are located on the A/C liquid line (high side) and suction line (low side).
1. Remove the valve caps. Recover the refrigerant.
2. Using a standard valve core tool, remove the valve core. Be careful to prevent any dirt/debris from entering the valve core opening or getting on
the replacement valve core.
CAUTION: A valve that is not fully seated can lead to damage to the valve during evacuation and charge. This can result in system refrigerant
discharge while uncoupling the charge adapters.
INSTALLATION
NOTE: When assembling the new valve core into the fitting, the core should be oiled with clean ND8 PAG compressor oil.
1. Install the new valve core into the fitting.
2. Evacuate the refrigerant system.
3. Charge the refrigerant system.
4. Install the valve caps.