Intrepid V6-2.7L VIN R (2003)
Audible Warning Device: Testing and Inspection
Chime System Diagnosis
NO TONE WHEN IGNITION SWITCH IS TURNED ON AND DRIVERS SEAT BELT IS UNBUCKLED AND FULLY RETRACTED.
1. Check driver's seat belt retractor switch for a ground when belt is unbuckled.
2. Use a DRB III scan tool to perform PCI bus diagnostics on the Body Control Module (BCM) for battery, ignition and seat belt switch input.
3. Use a DRB III scan tool to perform actuator diagnostics on BCM chime.
4. Check for battery feed at terminal J1-7 and ignition feed at terminal J1-5 of the BCM connector.
5. Check for tone in any other function.
NO FASTEN SEAT BELT LAMP WHEN IGNITION SWITCH IS TURNED ON.
1. Use DRB III scan tool to perform PCI bus diagnostics on BCM for battery and ignition switch input
2. Check for burned out bulb.
3. Using the DRB III scan tool, do the actuator test on cluster. Refer to proper Body Diagnostic Procedures.
4. Check for battery feed at terminal J1-7 of the BCM connector.
5. Check for ignition feed at terminal J1-5 of the BCM connector.
FASTEN SEAT BELT LAMP OR TONE CONTINUE FOR MORE THAN 10 SECONDS AFTER SEAT BELTS ARE FASTENED AND
IGNITION ON.
1. Use DRB III scan tool to perform PCI bus diagnostics on BCM for battery and ignition switch input.
2. Inspect the BCM connectors and wires for proper connection.
NO TONE WHEN HEADLAMPS ARE ON, IGNITION SWITCH IS OFF AND DRIVER'S DOOR IS OPEN.
1. Using a DRB III scan tool, check drivers door ajar switch for good ground when driver's door is open.
2. Use DRB III scan tool to perform PCI bus diagnostics on BCM for battery, ignition switch input, headlamp switch and driver's door input and
Chime Output Test.
3. Inspect BCM connectors and wires for proper connection.
4. Check for battery feed at terminal J1-7 of BCM connector.
5. Check headlamp switch.
NO TONE WHEN KEY IS LEFT IN IGNITION. IGNITION SWITCH IS IN THE OFF POSITION AND DRIVER'S DOOR IS OPEN.
1. Using a DRB III scan tool, check drivers door ajar switch for good ground when driver's door is open.
2. Use DRB III scan tool to perform PCI bus diagnostics on BCM for battery ignition switch input, key-in-switch and driver's door input and Chime
Output Test.
3. Inspect BCM connectors and wires for proper connection.
4. Check for battery feed at terminal J1-7 of BCM connector.
5. Check key-in switch.
CHIMES CONTINUE WHEN HEADLAMPS ARE TURNED OFF AND/OR KEY IS REMOVED FROM IGNITION.
1. Use DRB III scan tool to perform PCI bus diagnostics on BCM for headlamp or key-in-ignition inputs.
2. Check wiring for a grounded condition between key-in switch and BCM.
3. Inspect the BCM connectors and wires for proper connection.
NOTE: Refer to Electrical, Electronic Control Modules, Body Control Module, REMOVAL and INSTALLATION for service of the BCM.
