Intrepid V6-2.7L VIN R (2003)
Spot Lamp: Service and Repair
Spot Lamp - Police Replacement
REMOVAL
1. Remove the PDC cover and pull either the X or Y fuse, depending on which spot lamp is being serviced.
2. Raise the spot lamp from the stowed to the operating position.
3. Support the spot lamp sealed beam in position.
Fig.49 Spot Lamp Retaining Screws - Remove/Install
4. Remove the screws retaining the bezel to the spot lamp head assembly (Fig. 49).
5. Remove the bezel from the spot lamp head assembly
6. Tilt the sealed beam away from the spot lamp head assembly.
7. Disconnect the electrical connector to the spot lamp head assembly.
8. Remove the bulb from the lamp housing by moving the hold downs.
9. Remove bulb from lamp.
INSTALLATION
1. Position bulb into spot lamp assembly
2. Install the hold downs.
3. Connect the electrical connector to the spot lamp head assembly.
4. Tilt the sealed beam toward the spot lamp head assembly
5. Install the bezel to the spot lamp head assembly
6. Install the screws retaining the bezel to the spot lamp head assembly (Fig. 49) and tighten to 2 N.m (18 in. lbs.).
7. Lower the spot lamp from the operating to stowed position
8. Install the fuse and PDC cover
9. Verify system and vehicle operation