Intrepid V6-2.7L VIN R (2003)
Powertrain Control Module: Service and Repair
PCM Programming
PROGRAMMING THE POWERTRAIN CONTROL MODULE
IMPORTANT NOTE: Before replacing the PCM for a failed driver, control circuit or ground circuit, be sure to check the related component/circuit
integrity for failures not detected due to a double fault in the circuit. Most PCM driver/control circuit failures are caused by internal failure to
components (i.e. 12-volt pull-ups, drivers and ground sensors). These failures are difficult to detect when a double fault has occurred and only one DTC
has set.
NOTE: If the PCM and the SKIM are replaced, at the same time, program the VIN into the PCM first. All vehicle keys will then need to be replaced and
programmed to the new SKIM.
The SKIS Secret Key is an I.D. code that is unique to each SKIS. This code is programmed and stored in the SKIM, engine controller and transponder
chip (ignition key). When replacing the PCM it is necessary to program the secret key into the PCM.
NOTE: After replacing the PCM, you must reprogram pinion factor.
1. Turn the ignition on (transmission in park/ neutral).
2. Use the DRBIII(R) and select THEFT ALARM, SKIM then MISCELLANEOUS.
3. Select PCM REPLACED.
4. Enter secured access mode by entering the vehicle four-digit PIN.
NOTE: If three attempts are made to enter the secure access mode using an incorrect PIN, secured access mode will be locked out for one hour.
To exit this lockout mode, turn the ignition to the run position for one hour then enter the correct PIN. (Ensure all accessories are turned oft. Also
monitor the battery state and connect a battery charger if necessary).
5. Press ENTER to transfer the secret key (the SKIM Will send the secret key to the PCM).
