Intrepid V6-2.7L VIN R (2003)
Power Seat Control Module: Service and Repair
REMOVAL
1. Position the drivers seat as far upward and rearward as possible.
2. Open hood, disconnect and isolate the negative battery cable remote terminal from the remote battery post.
WARNING: SOME VEHICLES ARE EQUIPPED WITH SEATBACK MOUNTED AIRBAGS. BEFORE ATTEMPTING TO
DIAGNOSE OR SERVICE ANY SEAT OR POWER SEAT SYSTEM COMPONENT YOU MUST FIRST DISCONNECT AND
ISOLATE THE BATTERY NEGATIVE CABLE. THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE
BEFORE FURTHER SYSTEM SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO
DO SO COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
Fig.4 Memory Heated Seat/Mirror Module (MHSMM) Location
3. Remove the two module attaching screws.
4. Disconnect the module electrical connectors.
5. Remove the module from drivers seat.
INSTALLATION
1. Position the module under the drivers seat.
2. Connect the module electrical connectors.
3. Install the two module attaching screws.
4. Connect the negative battery cable remote terminal.
5. Position the drivers seat in its original position.
6. Verify correct system operation.
