Intrepid V6-2.7L VIN R (2003)
Battery Tray: Service and Repair
REMOVAL
1. Verify that the ignition switch and all accessories are OFF.
2. Turn the steering wheel to the full right position.
3. Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
4. Remove the air cleaner housing. Refer to the index for the location of the procedure.
5. Remove battery splash shield. Refer to the Body section of the service for the procedure.
6. Remove the two short bolts from the battery hold down and remove the hold down.
INSTALLATION
1. Install the battery hold down and install the hold down bolt. Torque to 16 Nm (150 in. lbs.).
2. Install battery splash shield. Refer to the Body section for the procedure.
3. Install the air cleaner housing.
