Intrepid V6-2.7L VIN R (2003)
3. Install the rotor on the hub and bearing assembly.
4. Install disc brake caliper back over brake rotor and align with caliper mounting holes on steering knuckle. Install the caliper to steering knuckle
guide pin bolts and tighten to a torque of 19 Nm (168 inch lbs.).
5. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification.
Then repeat the tightening sequence to the full specified torque of 129 Nm (95 ft. lbs.).
6. Lower the vehicle to the ground.
