Intrepid V6-2.7L VIN R (2003)
Windshield Washer Hose: Service and Repair
REMOVAL
1. Remove left headlamp unit. Refer to Electrical, Lamps/Lighting - Exterior, Headlamp Unit, REMOVAL.
2. Remove underhood silencer pad clips only along left rear of hood.
3. Carefully pull silencer pad away from hood.
4. Disconnect "Y" connector from hood.
5. Disconnect right and left hood nozzle hoses at "Y" connector.
6. Disconnect hose clips from hood, tower to tower beam, and fender beam.
7. Disconnect washer hose from top of reservoir and from washer pump discharge port.
8. Carefully pull washer hose up through engine compartment.
INSTALLATION
1. Route washer hose up through engine compartment.
2. Connect washer hose to top of reservoir and to washer pump discharge port.
3. Connect hose clips to hood, tower to tower beam, and fender beam.
4. Connect right and left hood nozzle hoses at "Y" connector.
5. Connect "Y" connector to hood.
6. install the underhood silencer pad clips along left rear of hood.
7. Install the left headlamp unit. Refer to Electrical, Lamps/Lighting - Exterior, Headlamp Unit, INSTALLATION.
Be sure to test and check system for leaks and pinched or kinked hoses.
