Intrepid V6-2.7L VIN R (2003)
Fig. 10 Washer Reservoir
8. If replacing the reservoir, you must transfer the pump and sensor to the new reservoir
NOTE: When transferring pump and sensor, make sure to use a new grommet for proper sealing and to avoid leaks.
INSTALLATION
NOTE: When transferring pump and sensor, make sure to use a new grommet for proper sealing and to avoid leaks.
1. If replacing the reservoir, you must transfer the pump and sensor to the new reservoir
2. Place reservoir into position in engine compartment, pivot the inboard side of the reservoir rearward.
3. Connect the washer filler hose.
4. Connect the washer hose.
5. Connect the pump and sensor wire connectors.
6. Install the four retaining bolts to the washer reservoir
7. Install the left headlamp assembly. Refer to Electrical, Lamps/Lighting - Exterior, Headlamp Unit (Intrepid), INSTALLATION.
8. Connect the negative battery cable remote terminal to the remote battery post.