Intrepid V6-201 3.3L Flex Fuel (1994)
REPAIR PROCEDURE:
This bulletin involves replacing the transmission front pump assembly and the transmission torque converter with one that has bonded converter clutch
friction material.
1.
Following the procedures outlined in the appropriate Service Manual, replace the torque converter and the transmission front pump assembly with
the parts identified in the parts section of this bulletin.
2.
Perform the transmission oil cooler and lines reverse flushing and flow check procedure as outlined in the appropriate Service Manual.
3.
Before performing the torque converter clutch break in reset procedure verify that the repair has corrected the shudder condition. Drive the vehicle
under the same conditions that caused the shudder. If the condition is corrected, go to step four.
NOTE:
SOME LIGHT SHUDDER MAY BE PRESENT BEFORE RESETTING THE EMCC BREAK-IN PROCEDURE. If severe shudder is still
present, refer to the diagnostic section of this bulletin and re-evaluate the items listed.
4.
Using the DRB II or III Scan Tool, perform the Torque Converter Clutch Break-in Procedure listed in the appropriate Service Manual.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
21-60-05-91
1993 - 1994
AA, AC, AG, AP, AS &
1992 - 1993
AY
6.1 Hrs.
1993 - 1994
LH
7.1 Hrs.
21-00-05-63
1993 - 1994
AS (Anti-Lock Brake System Equipped)
0.2 Hrs.
21-00-05-64
1993 - 1994
AS (All Wheel Drive Equipped)
1.2 Hrs.
FAILURE CODE: 52 - Improperly Machined