Intrepid V6-3.2L VIN J (1998)
Blower Motor: Service and Repair
Blower Motor and Wheel Assembly Replacement
The blower motor is located on the right side of the heater housing. The blower motor and the blower motor wheel must be replaced as an assembly.
REMOVAL
Negative Battery Cable Remote Terminal
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove lower right under panel duct.
3. Remove blower motor connector from resistor block/power module.
4. Squeeze blower motor wiring grommet and push grommet through blower motor housing cover.
5. Remove blower motor housing cover.
6. Remove blower motor retaining screws.
7. Lower blower motor from housing.
INSTALLATION
-
For installation, reverse the above procedures.
