Intrepid V6-3.2L VIN J (1998)
NOTE:
THE FOUR SPEAKER/COVER FASTENERS ARE UNIQUE AND SHOULD NOT BE MIXED WITH THE TRIM PANEL FASTENERS.
2.
Replace the (2) white clips on the trim panel with p/n 06504014.
3.
Replace the (1) green clip on the trim panel with p/n 06503204 (rear doors).
4.
Remove nuts attaching glass to lift channel and slide glass from regulator lift channel.
5.
Slide glass up into window frame, and support the window frame with a wood block on the door reinforcement.
6.
Disconnect the wiring harness from the motor.
7.
Loosen bolts attaching regulator support brace to door panel.
8.
Loosen screw and bolt heads from keyhole slots in door panel.
9.
Remove bolts attaching regulator to door panel.
10.
Slide regulator rearward and rotate forward end of roller channel through access hole in door panel.
11.
Remove regulator from door panel.
12.
If vehicle was built before October 1, 1999 (MDH 1001XX) go to step # 16. If vehicle was built after October 1, 1999 (MDH 1001XX) secure the
sector gear and mounting plate with a "C" clamp or similar clamping tool. This will prevent a sudden and forceful movement of the regulator when
the motor is removed.
13.
Remove three mounting screws that hold the motor gearbox to the regulator.
14.
Remove the motor from the regulator.
15.
Reverse steps to install motor to regulator.
16.
Reverse steps to install revised regulator/motor assembly into vehicle.
NOTE:
TO ADJUST GLASS CORRECTLY, SQUARE GLASS IN OPENING BY PULLING REARWARD AGAINST "B" PILLAR GLASS RUN AND
PUSH DOWN ON THE EQUALIZER CHANNEL WITH ENOUGH FORCE (2 LB. MAX) TO TAKE OUT ANY LOOSENESS IN SYSTEM
AND TIGHTEN FASTENER. DO NOT OVER ADJUST.
17.
Functionally check regulator and door accessories.
18.
Repeat procedure on other windows as necessary.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
