dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Engine Controls - MIL ON/False DTC's Set|Page 4214 > < Engine Controls - Rough Engine Idle on Cold Start-Up|Page 4209
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - MIL ON/False DTC's Set

NUMBER: 18-031-02

GROUP: Vehicle Performance

DATE: Oct. 14, 2002

THE MDS2 MUST BE OPERATING WITH CIS CD2107 OR HIGHER, AVAILABLE MAY 13, 2002. THIS IS THE SAME SOFTWARE
PROVIDED WITH TSB 18-015-02.

SUBJECT:
Flash: MIL Illumination, Erroneous Diagnostic Trouble Codes (DTC's)

OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software.

MODELS:
2002 (LH) 300M/Concorde/Intrepid

NOTE: 

THE BULLETIN APPLIES TO VEHICLES BUILT PRIOR TO APRIL 18, 2002 (MDH 0419XX).

SYMPTOM/CONDITION:

MIL illumination with any or all of the DTC's shown.

DIAGNOSIS:

Verify the condition of the wiring. Check for moisture or condensation in the Oxygen (02) Sensor connectors, chafed or pierced sensor leads, electrical
connections, and repair as necessary before proceeding. If DTC's are present, other than those listed above, record the DTC's on the repair order and
repair as necessary before proceeding further with this bulletin. If the conditions listed are present, perform the Repair Procedure.

PARTS REQUIRED

Engine Controls - MIL ON/False DTC's Set|Page 4214 > < Engine Controls - Rough Engine Idle on Cold Start-Up|Page 4209