Intrepid V6-3.5L VIN K (2003)
1. Install camshaft sprockets onto the camshafts. Install NEW sprocket attaching bolts into place. The 255 mm (10 in.) bolt is to be installed in the
left camshaft and the 213 mm (8 3/8 in.) bolt is to be installed into the right camshaft. Do not tighten the bolts; tightened at later step. Camshaft
sprocket mark should be positioned between the marks on the cover at both sprockets (Fig. 154).
2. Install the timing belt starting first at the crankshaft sprocket, then to remaining components in a counterclockwise direction (Fig. 155).
3. Install the belt around the last sprocket. Maintain tension on the belt as it is positioned around the tensioner pulley. Each camshaft sprockets mark
should still fall between the cover marks (Fig. 155).
NOTE: For timing belt tensioner reset procedure, Refer to TIMING BELT - REMOVAL.
4. Hold the tensioner pulley against the belt and install the reset (pinned) timing belt tensioner into the housing. Tighten attaching bolts to 28 Nm
(250 in. lbs.).
5. Remove tensioner retaining pin to allow the tensioner to extend to the pulley bracket.
