Intrepid V6-3.5L VIN K (2003)
14. Remove the exhaust manifold attaching bolts.
15. Remove the exhaust manifold and gasket.
INSPECTION
1. Inspect exhaust manifolds for damage or cracks.
2. Check manifold flatness.
3. Inspect the exhaust manifold gasket for obvious discoloration or distortion.
4. Check distortion of the cylinder head mounting surface with a straightedge and thickness gauge.
INSTALLATION
1. Install exhaust manifold and gasket. Tighten bolts starting at the center working outward to 23 Nm (200 in. lbs.).
2. Install heat shields and tighten attaching bolts to 12 Nm (105 in. lbs.).
3. Install oxygen sensor to manifold and connect electrical connector.
4. Install the A/C compressor mounting bracket.
5. Install engine oil dipstick tube.
6. Install the A/C compressor and drive belt.
7. Install a new V-Band clamp and tighten to 11 Nm (100 in. lbs.).
8. Raise vehicle on hoist.
9. Install the exhaust system.
10. Install and/or tighten nut attaching converter pipe support to transaxle mount to 47 Nm (35 ft. lbs.).
11. Lower the vehicle.
12. Install air cleaner housing and air inlet tube.
13. Connect negative cable.