Intrepid V6-3.5L VIN K (2003)
Spot Lamp: Service and Repair
Spot Lamp Assembly - Police Replacement
REMOVAL
CAUTION: Make sure that fuse F (master spot lamp feed) or either fuse X or Y (left or right spot lamp feed) are removed from the Power
Distribution Center (PDC) before performing service on the spot lamps.
1. Remove the fuse cover and pull either the X or Y fuse, depending on which spot lamp is being serviced.
2. Raise the spot lamp from the stowed to the operating position.
3. Using a trim stick (special tool #C-4755) or equivalent, gently pry out on the A-pillar trim to release it. This will allow access to the spot lamp
electrical connector.
4. Remove the instrument panel end cap.
Fig.53 Spot Lamp Assembly Electrical Connector
5. Disconnect the spot lamp electrical connector (located behind the instrument panel endcap) (Fig.53).
Fig.54 Spot Lamp Assembly Handle Retaining Bolt - Loosen/Tighten
6. Loosen, but do not remove the bolt retaining the handle to the outer tube (Fig. 54).