Intrepid V6-3.5L VIN K (2003)
Power Steering Line/Hose: Service and Repair
Installation
INSTALLATION - PRESSURE AND RETURN HOSES
1. Install the power steering hoses into the vehicle using the reverse of the removal procedure.
2. Raise the vehicle.
3. Install the power steering fluid return hose on the power steering fluid cooler. Be sure the hose clamp is installed past the upset bead on the power
steering fluid cooler.
4. 300M only-Reinstall front fascia.
5. Lower the vehicle until the tires are just clear of the floor
6. Install the power steering hoses onto the left frame rail by installing the routing clip bolts. Tighten the bolts to 10 Nm (89 inch lbs.).
7. Slide steering gear and intermediate shaft back into dash panel sealing boot. Align the steering gear mounting holes with its mounting holes in
crossmember.
