Intrepid V6-3.5L VIN K (2003)
6. Install the power steering pressure hose on the pressure fitting of the power steering pump. Tighten the power steering fluid pressure hose tube nut
to a torque of 47 Nm (35 ft. lbs.).
7. Install the power steering fluid supply hose onto the supply fitting on power steering pump. When installing the hose clamp on the power steering
fluid return hose be sure the clamp is installed past the upset bead on the nipple of the power steering fluid reservoir.
8. Lower vehicle.
9. Connect the battery ground cable onto the ground stud located on the strut tower.
10. Perform Power Steering Pump Initial Operation procedure to properly refill and bleed power steering system.
