Intrepid V6-3.5L VIN K (2003)
12. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence (Fig. 19), until all nuts are tightened to half
specification. Then repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
13. Lower vehicle to the ground.
CAUTION: When tightening hub and bearing assembly to stub shaft retaining nut, do not exceed the maximum torque of 142 Nm (105 ft. lbs.). If the
maximum torque is exceeded this may result in a failure of the driveshaft.
14. Apply the vehicle's brakes to keep vehicle from moving. Tighten the NEW stub shaft to hub and bearing assembly retaining nut to 142 Nm (105 ft.
lbs.) (Fig. 20).
