Journey AWD V6-3.5L (2009)
Towing Requirements - Trailer Lights AND Wiring
4 - Pin Connector
Whenever you pull a trailer, regardless of the trailer size, stoplights and turn signals on the trailer are required for motoring safety.
The Trailer Tow Package may include a 4- and 7-pin wiring harness. Use a factory approved trailer harness and connector.
NOTE: Do not cut or splice wiring into the vehicles wiring harness.
The electrical connections are all complete to the vehicle but you must mate the harness to a trailer connector. Refer to the following illustrations.
7- Pin Connector
Towing Tips
Before setting out on a trip, practice turning, stopping, and backing up the trailer in an area located away from heavy traffic.
Towing Tips - Automatic Transaxle
The DRIVE range can be selected when towing. However, if frequent shifting occurs while in this range, select the "3" range for 4-speed automatic or
the "5" range for 6-speed automatic.
NOTE: Using the "3" or "5" range while operating the vehicle under heavy operating conditions will improve performance and extend
transaxle life by reducing excessive shifting and heat build up. This action will also provide better engine braking.
If you REGULARLY tow a trailer for more than 45 minutes of continuous operation, then change the automatic transaxle fluid and filter according to the
interval specified for "police, taxi, fleet, or frequent trailer towing" in the Maintenance Schedule.
NOTE: Check the 4-speed automatic transaxle fluid level before towing. The 6-speed transaxle is sealed and the fluid level cannot be checked.
See your authorized dealer for assistance.
Towing Tips - Electronic Speed Control (If Equipped)
-
Don't use in hilly terrain or with heavy loads.
-
When using the speed control, if you experience speed drops greater than 10 mph (16 km/h), disengage until you can get back to cruising speed.
-
Use speed control in flat terrain and with light loads to maximize fuel efficiency.
Towing Tips - Autostick (R) (If Equipped)
