Journey AWD V6-3.5L (2009)
4. Install the four chassis brake tubes (2, 3, 5, 6) at the ICU hydraulic control unit (7). Tighten the tube nuts to 17 Nm (150 in. lbs.).
5. Install the primary (4) and secondary (1) brake tubes at the ICU hydraulic control unit (7). Tighten the tube nuts to 17 Nm (150 in. lbs.).
6. Push the brake tube bundle routing clips (with tubes) onto the studs on the dash panel.
7. Position the fresh air plenum and install the two mounting screws.
8. Install the wheelhouse brace (2). Install and tighten the eight mounting bolts (four each side) (1) to 48 Nm (35 ft. lbs.).
9. Install the cowl screen. Install the push-pins (1) securing the cowl screen to the wheelhouse brace and cowl. Rotate the screw (2) in the center of
the cowl screen 90° counterclockwise to lock the screen in place.
10. Install the wiper arms. See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Wiper Arm - Installation
