Journey AWD V6-3.5L (2009)
8. Connect the negative battery cable See: Starting and Charging/Battery/Service and Repair/Procedures/Battery Reconnection.
Rear Exhaust Maniverter
INSTALLATION - REAR EXHAUST MANIVERTER, AWD
1. Clean the right maniverter gasket sealing surfaces with an appropriate tool See: Engine/Service and Repair/Procedures.
2. Place the right maniverter in the engine compartment and position to allow installation of the maniverter lower heatshield (2).
3. Install the right maniverter lower heat shield (2) with heat shield retainers (1).
4. Install the right maniverter (6) and gasket (8) with retaining bolts (5). Tighten the bolts starting at the center working outward to 23 Nm (200 in.
lbs.).
5. Install the right maniverter upper heat shield (4) with heat shield retainers (1), (2), and (3).
