Journey AWD V6-3.5L (2009)
Panel Glove Box - Installation.
5. On RHD models, if equipped, install the silencer underneath the instrument panel.
6. Reconnect the negative battery cable.
7. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test.
DUAL ZONE RIGHT SIDE
1. Position the blend door actuator (1) to the right side of the HVAC air distribution housing (4) and connect the wire harness connector (3) to the
actuator.
2. Install the blend door actuator onto the air distribution housing. If necessary, rotate the actuator slightly to align the splines on the actuator with the
blend door linkage.
3. Install the two screws (2) that secure the blend door actuator to the air distribution housing. Tighten the screws to 1.2 Nm (10 in. lbs.).
4. Install the right front floor distribution duct onto the air distribution housing See: Air Duct/Service and Repair/Floor Distribution Duct -
Installation.
5. On LHD models, install the glove box binSee: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Instrument
Panel Glove Box - Installation.
6. On LHD models, if equipped, install the silencer underneath the instrument panel.
7. Reconnect the negative battery cable.
8. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test.
Rear
INSTALLATION
1. Position the rear blend door actuator (1) onto the rear heater-A/C housing (3). If necessary, rotate the actuator slightly to align the splines on the
actuator output shaft with those on the rear blend-air door pivot shaft (2).
