Journey AWD V6-3.5L (2009)
1. Position the rear mode door actuator (1) onto the rear heater-A/C housing (3). If necessary, rotate the actuator slightly to align the splines on the
actuator output shaft with those on the rear mode-air door pivot shaft (2).
2. Install the two screws (1) that secure the rear mode door actuator (2) to the rear heater-A/C housing (3). Tighten the screws to 1.2 Nm (10 in. lbs.).
3. Connect the wire harness connector (4) to the rear mode door actuator.
4. Install the rear heater-A/C housing See: Housing Assembly HVAC/Service and Repair/Removal and Replacement/Rear HVAC Housing
Installation.
5. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test.
Recirculation Door Actuator - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: Illustration shown with instrument panel removed for clarity.
