Journey AWD V6-3.5L (2009)
INSTALLATION
NOTE: The left and right demister ducts are serviced with the left and right instrument panel ducts as an assembly.
NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage while performing this procedure.
NOTE: LHD model shown in illustrations.
1. Position the passenger side instrument panel and demister duct assembly (1) to the instrument panel support (5) and connect the instrument panel
and demister duct assembly to the center duct (2) and to the defroster duct (3). Make sure the ducts are fully engaged.
2. Install the two push-pin retainers (4) that secure the passenger side instrument panel and demister duct assembly to the instrument panel support.
3. Position the driver side instrument panel and demister duct assembly (1) to the instrument panel support (5) and connect the instrument panel and
demister duct assembly to the center duct (2) and to the defroster duct (3). Make sure the ducts are fully engaged.
4. Install the two push-pin retainers (4) that secure the driver side instrument panel and demister duct assembly to the instrument panel support.
5. Install the cover onto the instrument panel.
6. Install the outboard instrument panel air outlets See: Air Register/Service and Repair/Air Outlet - Installation.
7. Install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Installation.
Ceiling Distribution Duct - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
