Journey AWD V6-3.5L (2009)
10. Install the rear A/C evaporator (4) into the rear heater-A/C housing (3). Guide the evaporator tubes (2) past the rear heater core tubes (1). Make
sure that the foam seals are properly installed on the evaporator.
11. Install the evaporator cover (3) onto the outboard side of the rear heater-A/C housing (2) and install the retaining screw (1). Tighten the screw to
1.2 Nm (10 in. lbs.).
12. Install the lower rear heater-A/C housing (6) onto the rear heater-A/C housing (4). Rotate and tilt the lower housing as necessary for installation.
13. Install the five screws (1 and 5) that secure the lower housing to the rear heater-A/C housing. Tighten the screws to 1.2 Nm (10 in. lbs.).
14. Install the metal retaining clip (2) that secures the lower housing to the rear heater-A/C housing.
15. Close the evaporator tube retaining bracket (3). Make sure the bracket retainers are fully engaged.
16. Install the wire harness connector (7) onto the lower rear heater-A/C housing.
