Journey AWD V6-3.5L (2009)
Glove Box Lamp: Service and Repair
Glove Box Lamp Bulb - Removal
BULB
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Open the glove box door.
3. Reach through and behind the upper outboard corner of instrument panel glove box opening to access the bulb (2) on the side of the glove box
lamp and switch unit (1).
4. Pull the base of the bulb straight out of the bulb holder.
