Journey AWD V6-3.5L (2009)
7. Reconnect the battery negative cable.
FIXED AUXILIARY LED AND CIRCUIT BOARD UNIT
1. Position the auxiliary LED and circuit board unit (4) into the lamp housing.
2. Install and tighten the six screws (2) that secure the printed circuit board to the lamp housing. Tighten the screws securely.
3. Reconnect the lamp wiring to the auxiliary LED wiring connector (3).
4. Reinstall and reconnect (1) the two articulated eyeball LED pods into the lamp housing.
5. Reinstall the rear LED dome/reading lamp unit. See: Service and Repair/Dome/Reading Lamp - Installation.
6. Reconnect the battery negative cable.
