Journey AWD V6-3.5L (2009)
15. Snap the oval wiring harness grommet into the oval hole on the "A" pillar (Figure 1).
16. Place the door grommet into position and install the two retaining screws (Figure 1).
17. Connect the remaining electrical connectors to their respective modules/connectors (Figure 2).
18. Connect the door latch electrical connector and close the access door (Figure 3).
19. Connect the door speaker electrical connector and install the door speaker (Figure 4).
20. Install the front door inner window seal.
21. Install the front door panel.
22. Install the front door window switch, grab handle cup, and release handle bezel.
23. Repeat steps 4 through 22 on the other front door.
24. Connect the negative battery cable.
25. Using Mopar Total Clean or equivalent, clean both front door panels
26. On vehicles equipped with Express Window Up/Down (sales code JSC), perform Steps 27 through 30.
27. Connect the wiTECH to the vehicle.
28. Clear all Diagnostic Trouble Codes (DTC's).
29. Clear/Denormalize the door modules using the following procedures:
a.
Click on the "Miscellaneous Functions" tab.
b.
Select "Denormalize Window/Reset ECU" and follow the directions to clear/denormalize the door module memory.
30. Relearn/Normalize the door modules using the following procedure:
a. Place the vehicle on a battery charger or have the engine running.
b. Raise the front door glass to the full-up position by pulling up on the window switch to its second detent and hold the switch until the front door
glass is fully closed. Continue to hold the window switch up for three seconds after the front door glass is fully closed.
c. Lower the front door glass to the full-down position by pushing down (depress) the window switch to its second detent and hold the switch until
the front door glass is fully open. Continue to hold the window switch down for three seconds after the front door glass is fully open.
d. Check the operation of the express-up and express-down features. If the express-up feature does not work, repeat the procedure starting with
Step 30b.
e. Check that the front door glass reverses when in the express-up mode by holding a pen in the path of the glass.
f.
Repeat steps 30b. through 30e. on the other front door.
