Journey AWD V6-3.5L (2009)
NOTE: The test light should be illuminated and bright with the ignition on and not illuminated with the ignition off. Compare the brightness
to that of a direct connection to the battery.
Is the test light illuminated as described above?
Yes
-
Go to 5.
No
-
Repair the open or short in the Fused Ignition Switch circuits.
-
Perform the PCM Verification Test. See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification
Tests/PCM Verification Test
5. CHECKING THE PCM FUSED IGNITION SWITCH CIRCUITS
1. Turn the ignition on.
CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in
poor terminal to pin connection. Install PCM Pinout Box 8815 to perform diagnosis.
2. Using a 12 volt test light connected to ground, check the PCM Fused Ignition Switch circuits.
3. Check each circuit with the ignition off, ignition on, engine not running position, and during cranking.
4. Wiggle test each circuit during the test to check for an intermittent open in the circuit.
NOTE: The test light should be illuminated and bright with the ignition on and not illuminated with the ignition off. Compare the brightness
to that of a direct connection to the battery.
Is the test light illuminated as described above?
Yes
-
Test complete.
No
-
Repair the PCM Fused Ignition Switch circuit(s) for as necessary.
-
Perform the PCM Verification Test. See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification
Tests/PCM Verification Test
