Journey AWD V6-3.5L (2009)
5. Remove the lower and upper trim (4) from the B-pillar (1). See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel-Removal.
6. Remove the screw (3) that secures the seat belt (5) turning loop to the height adjuster (2) on the upper B-pillar.
7. Using a trim stick or another suitable wide flat-bladed tool, gently pry the seat belt web guide (6) to unsnap it from the B-pillar.
8. Disconnect the body wire harness connector (1) from the seat belt tensioner initiator on the retractor (3).
9. On the driver side only, disconnect the second body wire harness connector from the seat belt switch connector receptacle on the retractor.
10. Remove the screw (4) that secures the lower retractor bracket to the inner B-pillar (2).
11. Remove the front seat belt and retractor from the B-pillar as a unit.
Second Row - Center
SECOND ROW - CENTER
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
