Journey AWD V6-3.5L (2009)
6. Position the web guide (6) to the B-pillar (1). Be certain the seat belt webbing (5) is not twisted between the retractor and the web guide.
7. Using hand pressure, press firmly and evenly on the web guide to snap it into place.
8. Position the seat belt turning loop onto the height adjuster (2) on the upper B-pillar. Be certain the seat belt webbing is not twisted between the
web guide and the turning loop.
9. Install and tighten the screw (3) that secures the turning loop to the height adjuster. Tighten the screw to 37 Nm (27 ft. lbs.).
10. Reinstall the upper (4) and lower trim onto the B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel-Installation.
11. Position the front seat belt (1) lower anchor to the bracket on the outboard side of the front seat (2) cushion frame. Be certain the seat belt webbing
is not twisted between the turning loop and the lower anchor.
12. Install and tighten the screw (4) that secures the lower anchor to the bracket on the outboard side of the front seat cushion frame. Tighten the screw
to 51 Nm (38 ft. lbs.).
13. Align the seat belt anchor cover (3) to the opening near the rear of the outboard seat side shield. Using hand pressure, press firmly and evenly on
the cover until it snaps into place.
14. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Service and Repair.
Second Row - Center
SECOND ROW - CENTER
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
