Journey AWD V6-3.5L (2009)
3. Lower the main fuel pump module into the fuel tank using caution not to bend the float arm.
NOTE: The main fuel pump module must be properly located in the fuel tank for the fuel level gauge to work properly.
4. Align the rubber O-ring seal and rotate the main fuel pump module to the orientation marks noted during removal. This step must be performed for
the fuel level gauge to work properly.
5. Position the lock-ring over top of the main fuel pump module.
6. Position the lock-ring remover/installer 9340 into the notches on the outside edge of the lock-ring.
7. Install a 1/2 inch drive breaker bar into the lock-ring remover/installer 9340.
8. Rotate the breaker bar clockwise until all seven notches of the lock-ring have engaged.
9. Install the fuel tank See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Removal and Replacement/Fuel
Tank - Installation.
AUXILIARY FUEL PUMP MODULE
WARNING: Risk of injury to eyes and skin from contact with fuel, Wear protective clothing and eye protection. Risk of poisoning from
inhaling and swallowing fuel. Pour fuel only into appropriately marked OSHA approved containers. Failure to comply may result
in serious or fatal injury.
