Journey AWD V6-3.5L (2009)
Battery Cable: Service and Repair
Battery Cables - Installation
INSTALLATION
BATTERY HARNESS
1. Position the battery harness into the vehicle.
2. One at a time, install the battery harness retaining pushpins, fasteners and routing clips until the harness is installed exactly where it was in the
vehicle.
3. Position the battery harness cable (2) onto the TIPM stud (3). Install the retaining nut (1) and tighten to 10 Nm (90 in. lbs.)
4. Install the TIPM on the bracket posts, push down until you hear a click.
NOTE: Diesel battery harness shown, gasoline battery harness similar.
5. On diesel engine equipped vehicles:
-
Connect the glow plug module connector (14)
-
Connect the cabin heater relay connectors (11 and 13)
-
Connect the in-line connector to the instrument panel harness (12)
6. Install the remote positive battery terminal (2) onto the mounting bracket on the left strut tower (15) by pushing straight down until fully engaged.
7. Remove the cover (1) from the remote positive battery terminal (2). Position the starter harness positive cable (3) onto the remote positive battery
