Journey AWD V6-3.5L (2009)
4. Position the steering gear in mounted position on the crossmember.
5. Install the two bolts (1) securing the steering gear (2) to the crossmember. Tighten the gear mounting bolts to 100 Nm (74 ft. lbs.).
6. Install the heat shield (1) over the steering gear (2). Install the mounting screws and push-pins. Tighten the screws to 6 Nm (53 in. lbs.).
7. Center the power steering gear rack in its travel as necessary.
NOTE: When installing the front suspension crossmember (1) it is very important that the crossmember be attached to the body in exactly the
same spot as when it was removed. Otherwise, the vehicle's wheel alignment settings (caster and camber) will be lost making wheel
alignment more difficult.
