Journey AWD V6-3.5L (2009)
rod end.
19. On each side of the gear, install the outer tie rod end (6) into the hole in the knuckle (2) arm. Start a NEW tie rod mounting nut (3) onto the stud.
While holding the tie rod end stud with a wrench, tighten the nut with a wrench or crowfoot wrench. Tighten the nut to 85 Nm (63 ft. lbs.).
20. On each side of the vehicle, install the tire and wheel assembly (1) See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and
Wheels - Installation. Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
21. Lower the vehicle.
22. Lift the dash seal into position and engage the retaining clips securing the dash seal to the dash panel.
23. Remove the steering wheel holder using care not to rotate the steering wheel.
