Journey AWD V6-3.5L (2009)
5. While holding the steering wheel (2) firmly in place, remove the bolt (4) that secures the steering wheel to the steering column shaft (1).
CAUTION: Do not bump or hammer on the steering wheel or steering column shaft when removing the steering wheel.
6. Install an appropriate wheel puller with hooked legs (1) on the steering wheel over the steering shaft.
CAUTION: Do not attempt to rotate the clockspring rotor once the steering wheel is removed. The clockspring must remain centered in its
travel to avoid overextending the clockspring inner parts, causing the clockspring to become inoperative. If removed and handled
properly using the correct procedures, it should remain in the "centered" position. If there is any question as to whether the
clockspring is in the "centered" position of travel, perform the clockspring centering procedure before installing the steering
wheel See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Procedures .
7. While holding the steering wheel firmly in the STRAIGHT-AHEAD position, remove the steering wheel from the steering column shaft splines
using the wheel puller.
