Journey AWD V6-3.5L (2009)
CAUTION: The strut assembly-to-knuckle attaching bolts (5) are serrated and must not be turned during removal. Proper removal is
required. Refer to the following steps for the correct method.
12. While holding the bolt heads stationary, remove the two nuts (2) from the bolts (5) attaching the strut (3) to the knuckle (6).
13. Remove the two bolts (5) attaching the strut (3) to the knuckle (6) using a pin punch.
NOTE: Do not allow the half shaft (1) to hang by the inner C/V joint; it must be supported to keep the joint from separating during this
operation.
14. Pull the knuckle (2) off the half shaft (1) outer C/V joint splines and remove the knuckle from the vehicle.
