Journey AWD V6-3.5L (2009)
9. Install the outer tie rod (6) ball stud into the hole in the knuckle (2) arm. Start the tie rod end-to-knuckle nut (4) onto the stud. While holding the
tie rod end stud with a wrench, tighten the nut with a wrench or crowfoot wrench to 85 Nm (63 ft. lbs.).
10. Install the wheel speed sensor head (2) into the knuckle (3). Install the mounting screw (1) and tighten it to 12 Nm (106 in. lbs.).
11. Install the routing clip (1) securing the wheel speed sensor cable to the knuckle (5).
12. Install the brake rotor, disc brake caliper and adapter. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and
Repair/Removal and Replacement/Brake Rotor - Installation
NOTE: Always install a new hub nut. The original hub nut is one-time use only and should be discarded when removed.