Journey AWD V6-3.5L (2009)
Wheel Bearing: Service and Repair
Front Hub and Bearing - Installation
INSTALLATION
1. Install the hub and bearing (1) by sliding it over the half shaft and into the knuckle.
2. Install the four bolts (2) fastening the hub and bearing (1) to the knuckle (3). Tighten the four bolts to 82 Nm (60 ft. lbs.).
3. Install the brake rotor, disc brake caliper and adapter. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and
Repair/Removal and Replacement/Brake Rotor - Installation
NOTE: Always install a new hub nut. The original hub nut is one-time use only and should be discarded when removed.
4. Clean all foreign matter from the threads of the half shaft outer C/V joint.
5. Install the hub nut (1) on the end of the half shaft (2) and lightly tighten it.
6. While a helper applies the brakes to keep the hub from rotating, tighten the hub nut (1) to 132 Nm (97 ft. lbs.).