Journey AWD V6-3.5L (2009)
Wheel Bearing: Service and Repair
Rear Hub and Bearing - Installation
ALL-WHEEL-DRIVE
1. With the brake shield in place on the knuckle, slide the hub and bearing over the axle half shaft and position it on the knuckle.
2. Install the four bolts (1) securing the hub and bearing to the knuckle. Tighten the bolts to 105 Nm (77 ft. lbs.).
CAUTION: Ensure that sensor mounting surface on bearing is clean before sensor installation.
3. Pass the wheel speed sensor head (2) through the hole in the brake shield, then push it into the mounting hole in hub and bearing (1) and align the
mounting screw hole.
4. Install a NEW mounting screw (2). Tighten the mounting screw to 6 Nm (55 in. lbs.).