Journey AWD V6-3.5L (2009)
Windshield Washer Hose: Description and Operation
Front Washer Hoses and Tubes - Description
FRONT
The front washer plumbing consists of a small diameter rubber hose (2) that is routed along the left front fender ledge (4) from the washer reservoir hose
(5) located at the left front corner of the engine compartment. The reservoir hose is attached to the front outlet nipple of the washer pump/motor unit near
the bottom of the reservoir. The hose is then secured by plastic push-in type retainers to the left fender ledge within the engine compartment to the left
side of the cowl plenum.
From the cowl plenum, the front hose is routed up toward the inner hood panel reinforcement (1). The hose is secured to the left hood hinge and the left
side of the inner hood panel reinforcement by plastic push-in type retainers, then is routed through the rear hood silencer brackets across the underside of
the inner hood panel. Plastic in-line fittings, a molded rubber tee and a molded rubber elbow provide the take outs for the two front washer nozzles.
Washer hose is available for service as roll stock, which may be cut to length. The molded plastic or rubber washer hose fittings cannot be repaired. If
these fittings are ineffective or damaged, they must be replaced.
