Journey FWD V6-3.5L (2009)
Cruise Control Switch: Service and Repair
Speed Control Switch - Installation
INSTALLATION
1. Install speed control switch (3) onto the locating pin (2) in the steering wheel.
2. Install speed control switch mounting screws (4) and tighten screws to 1.6 Nm (15 ins. lbs.).
3. Connect electrical connector (1) to speed control switch (3).
4. Install horn switch (2) to steering wheel.
5. Install horn switch mounting screws (3) and tighten screws to 8 Nm (71 ins. lbs.).
6. Connect electrical connector to horn switch.
7. Install driver's side airbag, See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Air Bag - Installation.
8. Connect negative battery cable, tighten nut to 4.5 Nm (40 in. lbs.).
9. Verify vehicle and system operation.
