Journey FWD V6-3.5L (2009)
Fog/Driving Lamp Bulb: Service and Repair
Fog Lamp Bulb - Removal
BULB
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Disconnect and isolate the battery negative cable.
2. Remove the lower inner front wheel house splash shield. See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Splash
Shield - Installation.
3. Disconnect the headlamp and dash wire harness connector from the front fog lamp bulb (2) connector receptacle (1).
4. Firmly grasp the bulb on the back of the front fog lamp housing and rotate it counterclockwise about 30 degrees to unlock it.
5. Pull the bulb straight out from the keyed opening in the housing.
